Frontside Slash Grind

also known as: Slash Grind · Slash · FS Slash

grind parkvert difficulty 3/10

Sign in to add this trick to your list.

roll 0° yaw 0° pitch 0° body 0°

Shown for a regular-footed rider. Teal ring + arrow = the rider's facing direction; teal band = the tail; a dot is where a hand holds the board - bright yellow for the front hand, amber for the back one, which is the whole difference between a mute and an indy. Board and rider rotate independently - each follows its own component. Unlock the camera (top right) to drag the view around.

How it works

A frontside 180 carved over the coping with the back truck slashed along it on the way round: riding up the transition, the rider turns frontside, and about a quarter of the way into the turn the back truck hits the coping and taps and scrapes it through the middle of the turn, while the board lies along the lip - then comes off it for the last part of the turn and the board goes back into the ramp nose first. The grind is very short, nothing to lock into or balance, just a loud scrape of the truck in the middle of a carve.

Step by step

  1. Pump up the transition with good speed, carving toward the coping.
  2. Start turning frontside as you reach the top, weighting the back foot.
  3. About a quarter of the way round, let the back truck hit the coping.
  4. Keep turning as it scrapes along - the board lies along the lip in the middle of the turn.
  5. Let it come off the coping for the last part of the turn and ride back in nose first.

Body mechanics

Front footLifts and steers the front truck up over the coping and back in.
Back footWeights the back truck onto the coping for the scrape.
ShouldersLead a frontside 180 the whole way round.
ArmsOut and low, balancing the carve.
GazeOn the coping as you hit it, then back down the ramp.

Delete this comment?

Discussion

Sign in to join the discussion.

No comments yet.

Something wrong with the Frontside Slash Grind?

No account needed. Say what's wrong and, if you can, what it should be - a source helps a lot. If you know exactly what the fix is, proposing the edit directly gets it in faster.

What kind of problem?