Heelflip Body Varial
also known as: Heelflip Sex Change
Shown for a regular-footed rider. Teal ring + arrow = the rider's facing direction; teal band = the tail; a dot is where a hand holds the board - bright yellow for the front hand, amber for the back one, which is the whole difference between a mute and an indy. Board and rider rotate independently - each follows its own component. Unlock the camera (top right) to drag the view around.
How it works
A heelflip during which the rider's body turns a frontside 180 around its own vertical axis while the board flips in place with no yaw, so the rider lands on the flipped board in the opposite stance. The heel flick must be pure roll with no shove, since the body's turn leaves no chance to correct the board's yaw, and the 180 comes from the arms and trunk after the flick. Turned backside instead, the same trick is the disco flip.
Step by step
- Set up for a standard heelflip with shoulders wound very slightly against the intended body spin.
- Pop and flick the heel off the toe-side nose corner cleanly, keeping the board's yaw dead-zero.
- Immediately rotate the body 180 frontside with arms and hips, leaving the board flipping in place.
- Spot the grip finishing its roll as your rotation completes.
- Catch and land in switch stance over the bolts.
Body mechanics
| Front foot | Delivers a clean, shove-free heel flick, then becomes the back foot on landing. |
|---|---|
| Back foot | Pops straight down, then swings around as the new front foot. |
| Shoulders | Quiet through the flick, then drive the 180 body spin hard immediately after. |
| Arms | The engine of the body varial - swung across the chest after the flick. |
| Gaze | Stays pinned on the flipping board while the body rotates around it. |
Discussion
Sign in to join the discussion.
No comments yet.